Throw Circles

SE362 Hammer Conversion Circle

Supply Unit: Four interlocking sections

Specification Compliance: IAAF, NCAA, NFHS

Material: Pliable PVC plastic

Converts discus ring into NCAA/IAAF compliant hammer ring. This innovative conversion circle fits into place instantly. Portable and guaranteed not to crack.

  • SE362 Hammer Conversion Circle

SE366 Aluminum Shot/Hammer Circle with Cross Bracing

Supply Unit: 2 sections

Specification Compliance: IAAF, NCAA, NFHS

Material: Extruded aluminum

1/4″ x 3″ aluminum strip with welded bracing greatly simplifies in-ground installation. Two piece unit bolts together prior to installation. Hardware included. Stays round during installation.

  • SE366 Aluminum Shot/Hammer circle w/ brace

SE367 Aluminum Discus Circle with Cross Bracing

Supply Unit: 2 sections

Specification Compliance: IAAF, NCAA, NFHS

Material: Extruded aluminum

1/4″ x 3″ aluminum strip with welded bracing greatly simplifies inground installation. Two piece unit bolts together prior to installation. Hardware included. Stays round during installation.

  • SE367 Aluminum Discus circle w/ brace

SportsEdge Throwing Circles

Circles are pre-formed from 2″ x 2″ x 1/4″ aluminum and help in the construction of concrete pads for the shot put, discus and hammer throw events. The vertical leg of the aluminum angle becomes the wall for the 3/4″ recessed throwing circle per the requirements of NCAA and IAAF regulations. Discus circles are 96.5″ in diameter. Shot/Hammer circles are 84″ in diameter. Either circle available in 1″ x 1″ and 2″ x 2″ sizes.

  • SE374 Aluminum Shot/Hammer Circle — 2″ x 2″ x 1/4″
  • SE375 Aluminum Discus Circle — 2″ x 2″ x 1/4″

SE370 Aluminum Discus Circle

Supply Unit: 4 sections

Specification Compliance: IAAF, NCAA, NFHS

Material: Extruded aluminum

1″ x 3/4″ x 1/4″ angle profile. Comes in 4 sections. Designed to be cast into the concrete.

  • SE370 Aluminum Discus Circle

SE371 Powder Coated Steel Discus Circle

Supply Unit: 3 Sections

Specification Compliance: NFHS

Material: Powder coated steel

1/4″ x 1-1/2″ formed flat steel. Designed for mounting to concrete surface.

  • SE371 Powder Coated Steel Discus Circle

SE372 Aluminum Shot Circle

Supply Unit: 3 sections

Specification Compliance: NFHS

Material: Extruded aluminum

1″ x 3/4″ x 1/4″ angle profile that attaches directly to SE360 or SE359 toeboard. Designed to be mounted on top of the concrete.

  • SE372 Aluminum Shot Circle

SE373 Powder Coated Steel Shot Circle

Supply Unit: 2 Sections

Specification Compliance: NFHS

Material: Powder coated steel

1/4″ x 1-1/2″ formed flat steel. Designed for mounting to concrete surface. Designed to fit SE359, SE360, SE361 and SE364 toeboards.

  • SE373 Powder Coated Steel Shot Circle

Throw Circles Downloads